Pololu 25D and 37D metal spur gearmotor, frame and gearbox length, 25d-25
Size drawing - 25d-25 values on the views - enlarged 2:1
Sym.
Lg Dm
Lm
Dimensi
Gearbox diameter
Gearbox length
Motor can diameter
Motor can length
Output shaft diameter
Across the shaft's flat
Shaft length from the face
Front boss diameter
Front boss height
Number of mounting holes
Mounting hole thread
Mounting hole depth
Hole offset from the shaft (25D)
Rear boss diameter
Rear boss height
Terminal reach past the can
Across the terminals
Terminal width
Terminal thickness
Encoder cover length (-enc)
Encoder cover diameter (-enc)
TITLE
'? CommunityCAD Size drawing, 25d-25
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c =a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L2 21.
Notes
Pololu's dimension diagrams are the parts' maker drawings (ADR 0089).
Largest stated where makers differ (ADR 0136 row 4); every maker's value on the page.
Screws, seams, end cap, dot, cover and mark illustrative: sheet DO2.
STANDARDS FOLLOWED
Pololu's dimension diagrams (maker drawings), TT Motor and NFP
FAMILY / DETAIL Pololu 25D and 37D gearmotor - 25d-25
SHEET
CC-GM-POLOLU-SZ-25d-25
A 21
REV SCALE PROJECTION UNITS
Dimensions in mm
SPEC VERSION
LICENSE
c5fa7152767e6d6286420b3e684bféabd9e752c5 CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.