ISO 2338 parallel pin (dowel pin), m6, 02.5
Size drawing - @2.5 values on the views - | = 10 shown - enlarged 20:1
Sym. Dimensi
flat end face Nominal diameter
0.005 6.002-0.008
~ 15° a x 15° to the surface m6 Tolerance band m6 (deviation from d)
End chamfer, axial length 8.4 ref
End chamfer angle to the surface, deg
Modeled diameter (d + m6 midpoint)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 3.
Notes
m6: the deviation from d (ISO 286-2 for the size's range); the model sits at its middle. h8, the other class ISO 2338 allows, isn't modeled (ADR 0054).
|= 10 shown lengths 6-24
TITLE
'? CommunityCAD Size drawing, ®2.5
STANDARDS FOLLOWED FAMILY / DETAIL
ISO 2338:1997 - ISO 286-2 (tolerance class m6) Parallel pin - @2.5
SHEET REV SCALE PROJECTION UNITS CC-1S02338-SZ-2.5 A 20:1 € Dimensions in mm
SPEC VERSION LICENSE PAGE d48b25e912c3742c9e061547a7d1d28F04a1258c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.