M.2 card envelope, 2260
Size drawing - 2260 values on the views - key B+M drawn; key M has no B slot (kb) - enlarged 1.5:1
Sym. Dimensio!
Card width Card length (the size's own)
PCB thickness
ko = 4.00* cl = 0.30, ca = 20.0 Edge tab width ht = 1501 +9 g9} — “ Shoulder radius
Key slot width Key slot depth from the edge
M slot off the centreline
B slot off the centreline (key B+M)
ks = 1.20*, rs = 0.50* dn = 3.50, dpt = 5.50 Gold finger pitch
kd = 3.50*
Gold finger width Fingers' leading edge from the edge (max) Top finger length from the edge kb = 5.625 Bottom finger length from the edge
bw = 19.85 1 ' c Lead-in chamfer length km = 6.125 ca Lead-in chamfer angle ko Top component keep-out from the edge (min)
ht Top component height, S3 (max)
dn Mounting notch @
pp = 0.50*, pw = 0.35%, pit = 2.00* dpt Top ground pad ®
dpb Bottom ground pad ©
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L114 - LO 10.
Notes
Values are the makers' drawings and text, reconciled (ADR 0140); no free standard. The card edge, notch, slots and heights are one drawing at every length; L is each length's own. ht2, hb, hb2 and the makers' Tp are recorded, not modeled (S3 only).
TITLE
'? CommunityCAD Size drawing, 2260
STANDARDS FOLLOWED FAMILY / DETAIL
Makers' M.2 drawings (no free standard) M.2 card - 2260
SHEET REV SCALE PROJECTION UNITS CC-M2CARD-SZ-2260 A 1.5:1 € Dimensions in mm SPEC VERSION LICENSE PAGE 6bd42c1c9dc7da8b80498b7267693balba4a3fdc CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.