CC-GT2-DS-20t-S revA Size datasheet - 20t-5
'?) CommunityCAD
GT2 timing pulley, 20 teeth, 5mm bore
Size datasheet: this size's values with their levels, conventions and sources.
For GT2 6 mm belts ona 5 mm Kea shaft Part key gt2-pulleys-20t-5 tii Files 1 STEP AP214 (simplified) 20t-5, hub end, 1:1 20t-5, side, 1:1 (hidden lines dashed)
Sym. Dimensi Value Level dp Pitch diameter (the belt's pitch line) 12.73 ll +2 da Outside diameter (the band) 12.22 L1- 2 df Flange diameter 17.399 l1 + 2 b Face width between the flanges 7.366 L1- 2 bf Width over the flanges 10.3% Lo - 1 L Overall length 15.875* lo - 1 dh Hub diameter 9.2456* Lo - 1 M Set screw thread 3x Lo - 1 th Gates' hub length (recorded) 5.9944 Lo - 1 de Misumi's face diameter (recorded) ox lo -1
Modeled value: nominal, else the midpoint of min-max. < / 2: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
Gates' design manual, Misumi GPA 2GT and SDP/SI tables Page 1/2 GT2 timing pulley - 20t-5 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 304229b833a653b73db51178a38d40486ee7c36b
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
. CC-GT2-DS-20t-5 revA '?) CommunityCAD Size datasheet - 20t-5
Conventions + Makers’ tables: No published standard: Gates' design manual, Misumi's GPA 2GT tables and SDP/SI's catalog page, each its own lineage. Pitch and outside diameters agree at every size.
* Where makers differ: The largest stated flange, face width, overall length and hub, so the model covers every maker's pulley; each maker's value is on the page. 16t-5 and 20t-5 stand on one lineage, labelled single source.
¢ Band, flanges and hub: The toothed band is a plain cylinder at the outside diameter: Gates' groove profile is proprietary. Each flange (bf - b) / 2 thick, the hub L - bf long, computed. The flange rims, hub end and bore chamfered. Illustrative, checked for fit only.
« Set screws: Radial plain bores at the thread's nominal diameter, through the hub's wall at mid-hub: two at 90 degrees, one on 16 teeth (Gates' note). Their place along the hub is house.
Sources
Source Publisher Retrieved sha256
gates-Light-power-precision Gates (distributor copy, Maxiparts) 2026-11-05 ef9f602173db misumi-gpa-2gt MISUMI 2026-11-07 16a48c814d68 (kept outside the repo)
The whole series (verification map, corrections, drawings): CC-GT2-DS.
Gates' design manual, Misumi GPA 2GT and SDP/SI tables Page 2/2 GT2 timing pulley - 20t-5 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 304229b833a653b73db51178a38d40486ee7c36b
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
