Extrusion corner bracket, per profile system, vs-single
Size drawing - vs-single values on the views - enlarged 5:1
Sym. | Dimensi vs-single
* L Leg length 20
x Upright leg length ai)
20*
~50* Counterbore floor Soe
.20* Hole diameter 7.20
11* Counterbore diameter
* Toe flat 1
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: LO 7.
Notes
No published standard: each value the reference maker's drawing, single source (ADR 0034).
Side walls, keys' width and length, fillet and mark are illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, vs-single
STANDARDS FOLLOWED
No published standard (makers' drawings)
FAMILY / DETAIL
Extrusion corner bracket - vs-single
SHEET
REV SCALE PROJECTION UNITS
CC-CORNBRKT-SZ-vs-single |A 5:1 € Dimensions in mm
SPEC VERSION
LICENSE
c7a962633bdbeSécéabcf253a98F14b1bbf3bd0F CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.