'?) CommunityCAD CC-CORNBRKT-DS-vs-single rev A
Size datasheet - vs- single
20 V -slot single corner bracket
Size datasheet: this size's values with their levels, conventions and sources.
For 20 V-slot aluminium extrusions | 1, 7 Part key extrusion - corner- brackets - | vs-single | O Files 1 STEP AP214 (simplified) vs-single, face, 1:1 vs-single, side, 1:1 (hidden lines dashed) Sym. Dimension Value Level L Leg length 20* lo-41 h Upright leg length 20* leo-4 w Width 20x lo. 41 tc Counterbore floor 3.50% lo- 1 d Hole diameter 7.20* lo. 41 de Counterbore diameter 11* lo- 1 fF Toe flat 1* lo. 41
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' drawings) Page 1/2 Extrusion corner bracket : vs- single - Dimensions in mm - CC-BY 4.0, lIronPixel Labs LLC spec c7a962633bdbeSécéabcf253a98F14b1bbF3bdoF
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
'?) CommunityCAD CC-CORNBRKT-DS-vs-single rev A
Size datasheet - vs- single
Conventions
¢ Casting: Side walls of the wall thickness, an inside fillet, key width and length and, on the slot 10 and 45 brackets, a curved diagonal: illustrative, not any maker's design.
« Mark: The CommunityCAD mark recessed 0.3 mm in an outside side wall. Illustrative.
« Values: No published standard: every maker casts its own bracket, so each size is the reference maker's own casting (Misumi, OpenBuilds, item), single source. item's sheets give only the outline and holes: its wall and key are house proportions, its hole ISO 273 medium for M8. On the 20 B-type slot 6 double, Misumi's drawing alone shows which holes sit on its rows. The two readings disagreed, and the owner accepted this layout: 4 holes on the first leg in two rows, 2 on the upright in one, no centre column.
« V-slot holes: OpenBuilds' drawing gives the holes of the 20 V-slot bracket no position, so they sit at the middle of the leg and of the width, a rule rather than a maker's dimension.
¢ Finish: Cast aluminium, the reference part's finish: render and metadata only. First leg's profile face at Z = 0, the upright's at X = 0, the keys beyond them.
Sources Source Publisher Retrieved sha256 openbuilds-angle-corner OpenBuilds (copy hosted on GitHub by eric- wieser/2.12 -robot) 2026-10-30 20ce1F20988b
The whole series (verification map, corrections, drawings): CC- CORNBRKT-DS.
No published standard (makers' drawings) Page 2/2 Extrusion corner bracket : vs- single - Dimensions in mm - CC-BY 4.0, lIronPixel Labs LLC spec c7a962633bdbeSécéabcf253a98F14b1bbF3bdoF
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.