The 20 mm shaft collar (DIN 705, form B, taper-pin hole) locks onto a 20 mm shaft with a 5 mm hole for a taper pin, reamed with the shaft; it is 32 mm across and 14 mm wide. Get it as simplified STEP files.

How these parts are made, and what the levels mean: read the method
- Also known as: 20 mm set collar, 20 mm adjusting ring, 20 mm stop collar, 20 mm Stellring
- Model id:
din705-b-d20
- Standard: DIN 705:2019 · size 20 mm
Files
| Part key | Simplified |
|---|
din705-b-d20 | STEP |
Dimensions

| Symbol | Name | min | nom | max | Modeled | Rule | Level |
|---|
| d1 | Bore diameter | | 20 | | 20 | nominal | L1 |
| d2 | Outside diameter | | 32 | | 32 | nominal | L1 |
| b | Width | | 14 | | 14 | nominal | L1 |
| d4 | Taper-pin diameter | | 5 | | 5 | nominal | L1 |
Drawing

As a PDF: CC-DIN705-SZ-20.pdf.
The 20 mm is the largest of the 10 DIN 705 shaft collars published here, from 4 mm to 20 mm.
- Bore diameter (d1): 20 mm on the 20 mm form B shaft collar, against 18 mm on the 18 mm.
- Outside diameter (d2): 32 mm on the 20 mm form B shaft collar, the same on the 18 mm.
- Width (b): 14 mm on the 20 mm form B shaft collar, the same on the 18 mm.
- Taper-pin diameter (d4): 5 mm on the 20 mm form B shaft collar, the same on the 18 mm.
Other sizes
Conventions
- Form A: simplified and threaded; form B has no thread, simplified only. STEP AP214, millimetres, Z along the bore axis, the plain face at Z = 0 and the chamfered face at Z = b, the hole on +X at Z = b/2.
- d1 at the midpoint of its H8 band and d2 at the midpoint of its h13 band, from the ISO 286-2 grade widths; b, d3 and d4 at their nominals.
- Form A, threaded level: ISO 68-1 basic internal thread in the hole, right hand, coarse pitch, over the full wall.
Documents
Sources
dinmark-din705, dinmark-din705-b, fasten-it-din705, fasten-it-din705-b, maedler-din705. Full citations: the method page and this size's datasheet.
Found an error? Use the feedback section on this page.
Comments
Sign in to leave a comment.
Loading comments...