20 B-type slot 6 M3 Slide-in T-slot Nut datasheet (PDF)

Datasheet — 20 B-type slot 6 M3 Slide-in T-slot Nut by Milo

Open the PDF
20 B-type slot 6 M3 Slide-in T-slot NutGet the CAD model20 B-type slot 6 M3 Slide-in T-slot NutCC-TNUTS-DS-b6-M3.pdf

Text of this datasheet

CC-TNUTS-DS-b6-M3 revA Size datasheet - b6-M3

'?) CommunityCAD

20 B-type slot 6 M3 slide-in T-slot nut

Size datasheet: this size's values with their levels, conventions and sources.

For 20 B-type slot 6 aluminium extrusions ( ) Part key slot-nuts-slide-in-b6-m3 Files 2 STEP AP214 (simplified, threaded) b6-M3, top, 2:1 b6-M3, end, 4:1 (hidden lines dashed) Sym. Dimension Value Level Ww Body width across the slot 10* lo- 4 a0 Body length along the slot 10* lo- 4 b Neck width 5.8* Lo - 1 h Overall height 4.1* Lo - 1 k Body height 3.3% lo- 1 n Neck height 0.8% lo- 1

Modeled value: nominal, else the midpoint of min-max. < / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.

No published standard (makers' drawings) Page 1/2 Slide-in T-slot nut - b6-M3 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 304229b833a653b73db51178a38d40486ee7c36b

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.

---

. CC-TNUTS-DS-b6-M3 rev A '?) CommunityCAD Size datasheet - b6-M3

Conventions

« Lead-ins and flanks: 45 degree chamfers of I/10 on the four corners at the nut's two ends, and the body's lower edges chamfered 45 degrees by k/2. Both illustrative, not any maker's dimensions.

« Values: No published standard: each value the reference maker's drawing (Misumi). A second maker's value counts as agreeing where the slot leaves room for the difference, computed from the profile's data, and a size where a value stands on one maker is labelled single source.

¢ Fit: A nut is checked against its slot system's one-cell profile, never fitted to it: neck no wider than the opening, width no wider than the undercut, body no taller than the cavity.

« Finish: Brushed stainless: render and metadata only. No markings, no serrations, other edges sharp. Bottom face at Z = 0, the neck toward +Z.

Sources

Source Publisher Retrieved sha256

misumi-slide-in-nuts MISUMI 2026-11-02 #9cc15la2bdf (kept outside the repo) pule-misumi-slide-in-nut-neck CommunityCAD 2026-11-03 9a8798514ca2

The whole series (verification map, corrections, drawings): CC-TNUTS-DS.

No published standard (makers' drawings) Page 2/2 Slide-in T-slot nut - b6-M3 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 304229b833a653b73db51178a38d40486ee7c36b

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.