ISO 2339 taper pin, 1:50, unhardened, 02
Size drawing - @2 values on the views - | = 10 shown - enlarged 20:1
Sym. | Dimensio @2
2 1.96-2
Small-end diameter (10) d+ 1/50
| 0.25 ref
End dome, axial length | = 0.25 ref
Taper on diameter, 1:x Large-end diameter at | = 30 (d +1/ x)
Small-end dome radius (from d and a)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L1 3.
Notes
d sits at its nominal: h10 puts the band below it, so the nominal is d max.
The large end is d + | / 50, so it grows with the length (the makers' formula). Types A (ground) and B (turned) differ only in finish: one model for both.
| = 10 shown . lengths 10-35 taper 1:50
TITLE
Ja = 0.25 ret '? CommunityCAD Size drawing, 2
STANDARDS FOLLOWED FAMILY / DETAIL
ISO 2339:1986 Taper pin - 02
SHEET REV SCALE PROJECTION UNITS CC-1802339-SZ-2 A 20:1 € Dimensions in mm SPEC VERSION LICENSE PAGE
e€79bc69C722a7450eb0be681b46a36c48d05506e CC-BY 4.0 IronPixel Labs LLC 1/1
spherical dome
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.