2 mm Split Pin, ISO 1234 size drawing (PDF)

Datasheet — 2 mm Split Pin, ISO 1234 by Milo

Open the PDF
2 mm Split Pin, ISO 1234Get the CAD model2 mm Split Pin, ISO 1234CC-ISO1234-SZ-2.pdf

Text of this datasheet

ISO 1234 split pin, 2

Size drawing - 2 values on the views - | = 12 shown - enlarged 10:1

|= 12 shown lengths 10-40

bearing point

ends square cut (end form not specified)

'? CommunityCAD

Sym. | Nominal size le @)

1.75 1.7-1.8

Pin diameter, across both legs

1.875 1.25-2.50

Extended prong (long leg past short)

4 ref

Eye length, bearing point to eye end

Eye width, outside

Eye path radius ((c - d)/2)

Eye path centre above bearing (b - c/2)

Source levels

Main value = the modeled value (nominal, else the middle of min-max).

Grey under a value = its min-max, where the source gives both.

< / = = the source gives only that limit, modeled at it. ref = reference.

L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.

LO = one source only: printed amber and marked *.

c = a source value was corrected; the datasheet says how.

House convention = a detail no source dimensions, drawn to a stated house rule.

This size's values: L2 4.

Notes

Nominal size = the split-pin hole's diameter; d is the pin's own, smaller. b s in the standard: a reference value (ref), modeled as given.

b runs from the eye's far end to where it bears on the hole; | from there. Ends square cut: end form not specified by the standard.

TITLE

Size drawing, 2

STANDARDS FOLLOWED

ISO 1234:1997

FAMILY / DETAIL

Split pin - 2

SHEET

CC-1S01234-SZ-2

REV SCALE PROJECTION

A 10:1

UNITS

Dimensions in mm

SPEC VERSION cfd05b053c736a4F15ba3030aa41Febd40cdc205

LICENSE CC-BY 4.0 IronPixel Labs LLC

PAGE

1/1

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.