DIN 705 adjusting ring (shaft collar), forms A and B, 18
Size drawing - 18 values on the views - form A shown - enlarged 2:1
Sym. | Dimensi 3
18.0135 18-18.027
di Bore, H8 (band middle)
. , 31.805 d2 = 31.805 d2 Outside, h13 (band middle) sotto
31.61-32
Width, js14 14
Outside chamfer, 0.1b
d3 Set-screw thread, form A
d1 = 18.013 18-18.027 ls Set-screw length, form A
d4 Pin hole, form B
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
d2 = 31.805 L2 = the standard itself (or its complete free preview, or the maker's drawing). 31.61-32 L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L16.
Notes
d1, d2: the middle of the H8 / h13 band; grey = the band's limits (ISO 286-2).
c: the standard's drawn 0.1b x 45 deg, entered by the owner (#599), no source level.
The views show form A. I_s: the screw's length, not modeled.
Form B: the same collar with a d4 hole in place of d3, through the near wall only.
View from above
TITLE
'? CommunityCAD Size drawing, 18
STANDARDS FOLLOWED FAMILY / DETAIL
DIN 705:2019-03 (as tabulated) - ISO 286-2 (H8, h13) Shaft collar - 18
SHEET REV SCALE PROJECTION UNITS CC-DIN705-SZ-18 A 2:1 € Dimensions in mm SPEC VERSION LICENSE PAGE 946d39588085996aee8F621a618103eb3a8F37bd CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.