NEMA hybrid stepper motor, frame x body length, 17x48
Size drawing - 17x48 values on the views - enlarged 2:1
Sym. Dimensi
Body length (house)
BD Body square
Mounting hole spacing
Number of mounting holes
Tapped hole thread
Pilot diameter 21.9989
2 0.762-2.286
Pilot height
Shaft diameter 5
Shaft length from the mounting face 24
Across the shaft's flat
Lf Flat length
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
OBD = 42.3 Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L110 - LO 1.
Notes
NEMA ICS 16 for frames 17, 23, 34; makers' drawings for the rest (ADR 0034). Body length: a house length backed by the makers (#1227 item 2 A).
Caps, stack, connector and label illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, 17x48
STANDARDS FOLLOWED FAMILY / DETAIL
NEMA ICS 16 Table 4 (frames 17, 23, 34) and makers' drawings NEMA hybrid stepper motor - 17x48 SHEET REV SCALE PROJECTION UNITS CC-NEMA-SZ-17x48 A 2:1 € Dimensions in mm SPEC VERSION LICENSE PAGE O2F48ec29F9e7bFFOeF7S6F4F5d939300beee1e6 CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.