CC-GT2-DS-16t-S revA Size datasheet - 16t-5
'?) CommunityCAD
GT2 timing pulley, 16 teeth, 5 mm bore
Size datasheet: this size's values with their levels, conventions and sources.
For GT2 6 mm belts ona 5 mm
Part key gt2-pulleys-16t-5 Files 1 STEP AP214 (simplified) = 16t-5, hub end, 1:1 16t-5, side, 1.5:1 (hidden lines dashed)
Sym. Dimension Value Level dp Pitch diameter (the belt's pitch line) 10.19 ll - 2 da Outside diameter (the band) 9.68 L1- 2 df Flange diameter 14.732 L1- 2 b Face width between the flanges 7.366 L1- 2 bf Width over the flanges 10.3* lo- 1 L Overall length 14.2748* lo- 1 dh Hub diameter 14.732* lo- 1 M Set screw thread 3x lo- 1 th Gates' hub length (recorded) 5.969% Lo - 1 de Misumi's face diameter (recorded) Tx lo -1
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
Gates' design manual, Misumi GPA 2GT and SDP/SI tables Page 1/2 GT2 timing pulley - 16t-5 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 7c5f93bb2a1674fad1ed142d21f252056a66a74e
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
* CC-GT2-DS-16t-S revA '?) CommunityCAD Size datasheet - 16t-5
Conventions + Makers’ tables: No published standard: Gates' design manual, Misumi's GPA 2GT tables and SDP/SI's catalog page, each its own lineage. Pitch and outside diameters agree at every size.
« Where makers differ: The largest stated flange, face width, overall length and hub, so the model covers every maker's pulley; each maker's value is on the page. 16t-5 and 20t-5 stand on one lineage, labelled single source.
¢ Band, flanges and hub: The toothed band is a plain cylinder at the outside diameter: Gates' groove profile is proprietary. Each flange (bf - b) / 2 thick, the hub L - bf long, computed. The flange rims, hub end and bore chamfered. Illustrative, checked for fit only.
« Set screws: Radial plain bores at the thread's nominal diameter, through the hub's wall at mid-hub: two at 90 degrees, one on 16 teeth (Gates' note). Their place along the hub is house.
Sources
Source Publisher Retrieved
a256
gates-Light-power-precision Gates (distributor copy, Maxiparts) 2026-11-05 ef9f602173db misumi-gpa-2gt MISUMI 2026-11-07 16a48c814d68 (kept outside the repo)
The whole series (verification map, corrections, drawings): CC-GT2-DS.
Gates' design manual, Misumi GPA 2GT and SDP/SI tables Page 2/2 GT2 timing pulley - 16t-5 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 7c5f93bb2a1674fad1ed142d21f252056a66a74e
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.