1/4-20 Camera Mounting Screw, ISO 1222 size drawing (PDF)

Datasheet — 1/4-20 Camera Mounting Screw, ISO 1222 by Milo

Open the PDF
1/4-20 Camera Mounting Screw, ISO 1222Get the CAD model1/4-20 Camera Mounting Screw, ISO 1222CC-ISO1222-SZ-1-4-20.pdf

Text of this datasheet

ISO 1222 camera screw, 1/4-20

Size drawing - 1/4-20 values on the views - L = 10, house length (owner, #438) - enlarged 5:1

Sym. | Dimensiot 1/4-20

Pitch (25.4 / tpi) 1.270

6.167 Thread di Table 2) dk = 13.567 house REESE) CLEMO G) 6.012-6.322

| Thread pitch diameter (Table 2) 5.426 5.355-5.497

Thread minor diameter (Table 2) 4.975 k = 3.7 house Protrusion from the bearing face (Fig. 1b)

Thread length from the end (Fig. 1b)

End chamfer length (Fig. 1b) dn = 4.287 house “vs

Bearing face recess limit (clause 4)

L = 10 house Head diameter (2.2 d, house) Head height (0.6 d, house)

d = 6.167 6.012-6.322

Slot width (0.16 d, house)

Hex socket across flats (0.5 d, house)

end face d1 = 4.975 Captive neck (0.9 di, house)

D-ring wire (0.12 d, house)

Source levels Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both. < / = = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate. LO = one source only: printed amber and marked *. c = a source value was corrected; the datasheet says how. House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 8 - LO 6. Notes Thread diameters at the band midpoint, else the basic (designation nominals, ADR 0014). Figure 1 values are figure reads of the preview: one lineage (LO), modeled at the limit. n = 0.987 house dk, k, n, s, dn, w: illustrative house rule (#1120 item 2 B), not any maker's design. dr limits a recess in the mating face; not a feature of the screw. s = 3.084 house L: house length (owner, #438), the whole mm the makers' stated lengths round to.

w = 0.74 house (D-ring)

TITLE

'? CommunityCAD Size drawing, 1/4-20

STANDARDS FOLLOWED FAMILY / DETAIL

ISO 1222:2010 Camera screw - 1/4-20

SHEET REV SCALE PROJECTION UNITS CC-1801222-SZ-1-4-20 A 5:11 € Dimensions in mm

SPEC VERSION LICENSE PAGE cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.