Sealed lead-acid (SLA) battery, 12V12Ah
Size drawing - 12V12Ah values on the views - scale 1:2
he = 94.1*
bt = 6.35, tl = 7.95% tt = 0.8* te = 3.4*
Sym. Dimensio!
Case length (Yuasa, CSB)
Case width (Yuasa, CSB)
Overall height (largest stated)
Container height, lid top (CSB fig.)
Case end to the tab's shoulder (CSB fig.)
Case end to the lug plate's face (CSB fig.)
Near long face to the centreline (CSB fig.)
Near long face to the lower edge (CSB fig.)
Far long face to the lug's centre (CSB fig.)
Terminal centre to centre (CSB fig.)
F2 tab width (Yuasa, CSB fig.)
F2 tab length (CSB fig.)
F2 tab thickness (CSB fig.)
F2 shoulder to hole centre (CSB fig.)
B1 lug width (CSB fig.)
B1 lug thickness (CSB fig.)
B1 lug hole (M5 bolt, CSB fig.)
B1 lug top to hole centre (CSB fig.)
B1 lug top above the base (CSB fig.)
+ terminal centre, x (computed)
+ terminal centre, y (computed)
- terminal centre, x (computed)
~ terminal centre, y (computed)
Lid band, h_case / 8 (house)
Pocket floor height (house)
12V12Ah
151.0
98.0
'? CommunityCAD
TITLE
Size drawing, 12V12Ah
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
</ 2 = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c =a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L1 4 - LO 7. Notes
CSB fig. = figure read of CSB's page 2 drawing, two reads that agree (ADR 0055): LO.
A dash: that size's sheet has no such callout. y and ye are different callouts, never one.
xp, yp, Xn, yn: computed from the row values, in the frame. b, f: illustrative house rule.
STANDARDS FOLLOWED No published standard; Yuasa and CSB data sheets
FAMILY / DETAIL
SLA battery -12V12Ah
SHEET
CC-SLA-SZ-12V12Ah
REV SCALE
A 1:2
PROJECTION
UNITS
Dimensions in mm
SPEC VERSION
9325b178989ac5d161502b81caa4f9ee4cfda308
LICENSE
CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.