Wire fan guard, square DC axial fans, 120
Size drawing - 120 values on the views - scale 1:1
Hole spacing
e = 104.78 Hole diameter (eyelet inside)
Outside ring diameter
Height
dring Ring wire diameter
drib — Rib wire diameter
dring = 1.8
e = 104.78 Source levels Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both. < / = = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate. LO = one source only: printed amber and marked *. c = a source value was corrected; the datasheet says how. House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L15 - LO 1. Notes No published standard: values are reconciled from makers' drawings (ADR 0034). D, h and the wire sizes: the largest any maker states where they differ (ADR 0091). Rings, ribs and eyelet loops are illustrative: sheet DO2. 7 rings at pitch p = 8.13 mm (house rule, gap < 6.35 mm; sheet DO2).
@D=115.6
drib = 1.8*
TITLE
'? CommunityCAD Size drawing, 120
STANDARDS FOLLOWED FAMILY / DETAIL
No published standard (makers' drawings) Wire fan guard - 120
SHEET REV SCALE PROJECTION UNITS
CC-FANGUARD-SZ-120 A 1:1 € Dimensions in mm SPEC VERSION LICENSE PAGE
a6ce283c84109cF9CC954863c229586eb671d04c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.