NEMA hybrid stepper motor, frame x body length, 11x41
Size drawing - 11x41 values on the views - enlarged 2.5:1
OBD < 28.3
Sym. Dimensi
Body length (house)
BD Body square
Mounting hole spacing
Number of mounting holes
Tapped hole thread
Pilot diameter
Pilot height
Shaft diameter
24
Shaft length from the mounting face
Across the shaft's flat
Lf Flat length
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L110 - LO 1.
Notes
NEMA ICS 16 for frames 17, 23, 34; makers' drawings for the rest (ADR 0034). Body length: a house length backed by the makers (#1227 item 2 A).
Caps, stack, connector and label illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, 11x41
STANDARDS FOLLOWED
NEMA ICS 16 Table 4 (frames 17, 23, 34) and makers' drawings
FAMILY / DETAIL
NEMA hybrid stepper motor - 11x41
SHEET
CC-NEMA-SZ-11x41
REV SCALE PROJECTION
A 2.5:1
UNITS
Dimensions in mm
SPEC VERSION
LICENSE
O2F48ec29F9e7bFFOEF75S6F4F5d939300beeeled CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.