ISO 1234 split pin, 0.6
Size drawing - 0.6 values on the views - | = 4 shown: enlarged 20:1
|= 4 shown lengths 4-12
bearing point
d= 0.45 0.4-0.5
ends square cut (end form not specified)
Sym. | Nominal size le @)
Pin diameter, across both legs
Extended prong (long leg past short)
Eye length, bearing point to eye end
Eye width, outside
Eye path radius ((c - d)/2)
Eye path centre above bearing (b - c/2)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 4.
Notes
Nominal size = the split-pin hole's diameter; d is the pin's own, smaller.
b s in the standard: a reference value (ref), modeled as given.
b runs from the eye's far end to where it bears on the hole; | from there.
Ends square cut: end form not specified by the standard.
TITLE
'? CommunityCAD Size drawing, 0.6
STANDARDS FOLLOWED
ISO 1234:1997
FAMILY / DETAIL
Split pin - 0.6
SHEET
CC-1S01234-SZ-0.6 A 20:1
REV SCALE PROJECTION
UNITS
Dimensions in mm
SPEC VERSION
LICENSE
4aeSbf9e66e8308247edfcSddd7a850ae355Fc17 CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.